Plumbing Repair and Installation in Garland, TX

This page covers fixture-level plumbing repair and installation: faucets, sinks, shower and tub valves, shut-off valves (angle stops), pressure reducing valves, short supply line runs, garbage disposals, and hose bibs. For toilets, we have a dedicated Garland toilet page. For water heaters, a dedicated Garland water heater page. For sewer line and drain cleaning, dedicated Garland pages for each. For full re-piping, a dedicated pipe leak repair and re-piping page. Call 214-918-6109 if you're unsure which page applies.

Many 1950s-1970s Garland homes were built with galvanized steel supply lines. Galvanized corrodes from the inside out over decades. The corrosion doesn't just weaken the pipes — it also seizes shut-off valves so they won't close when you need them, and it flakes rust into faucet cartridges and PRV bodies. Once one angle stop fails, the others in the same home are usually not far behind. We replace corroded angle stops with quarter-turn ball valves that seal reliably on the first use and will last decades.

Fixture and valve repair pricing depends on the specific fixture (faucet cartridge repair vs. full faucet replacement vs. valve body swap), accessibility (some shower valve replacements require drywall access), and whether related components (supply lines, angle stops) need replacement while we're already in the wall. We diagnose on-site and quote flat-rate before any work begins. The number on the quote is the number on the invoice — no surprise charges mid-job. Call 214-918-6109 to schedule.

Repair if: the faucet is under 10 years old, the finish is intact, the cartridge type is still manufactured, and the fixture matches your kitchen or bath design. Replace if: the faucet is 15+ years old (typical DFW hard water lifespan), the finish is pitted or discolored, the cartridge type has been discontinued (common on older Delta, Moen, and Kohler models), or the fixture doesn't match your current design. For a specific answer on your fixture, call for on-site diagnosis — we bring the cartridge type reference and can tell you within a few minutes whether repair parts are still available.

Yes — hose bib replacement is one of the most common repair calls we get after winter cold snaps. Standard hose bibs freeze and split at the valve seat when temperatures drop below 20°F, especially in homes with uninsulated outdoor plumbing. When we replace a frozen hose bib, we usually recommend upgrading to a frost-free hose bib — the valve body sits inside the house wall where it stays above freezing, dramatically reducing repeat freeze failures. Frost-free installation is more involved (requires access to the interior side) but the once-and-done nature saves repeat calls.

Garland is directly adjacent to our Mesquite shop at 844 Dalworth Dr., Suite 10. Most Garland calls are reached within 15 to 30 minutes from dispatch during business hours. Active plumbing emergencies (burst pipes, active leaks, gas emergencies after the gas company has stabilized the situation) are prioritized and typically dispatched same-day when reported before noon Monday through Friday. After-hours, weekend, and holiday calls accepted — call 214-918-6109 to confirm current availability.