Bathtub Repair and Installation in Mesquite

Usually the waste-and-overflow gasket. That seal only sees water when the tub is filled past the overflow plate, so a tub that leaks during a full bath and stays dry during a shower points straight at it. We confirm by testing the spout, shower, and overflow separately to isolate which component is failing.

Not always. Many Mesquite homes have an access panel behind the tub in an adjoining closet or hallway, which reaches the drain and waste-and-overflow without touching tile. If there is no panel, cutting a small one is usually less invasive and less expensive than opening the surround, and it makes future repairs easier.

Tub clogs are almost always hair and soap collected at the drain shoe. The stopper has to come out first, and different stopper types remove differently. We clear it with a small drum auger through the overflow rather than chemicals, which damage older drain lines. If the tub clogs repeatedly or backs up alongside other fixtures, the problem is downstream in the drain line, not in the tub.

Yes. We pull the old tub, set the new one level and properly supported, and connect the drain, waste-and-overflow, valve, and spout. The main thing to confirm first is drain location, since tubs have left-hand or right-hand drains and the new tub has to match the existing rough-in. Tile and surround work is typically a separate contractor, and we tell you where our scope ends before starting.

Often it is the tub and shower valve rather than the heater, especially if hot water elsewhere in the house is fine. Valve cartridges wear out and North Texas water accelerates it. Replacing the cartridge restores temperature control. If hot water is short throughout the house, that points at the water heater instead, and we check both.