A grease trap is a small indoor unit, usually under or beside a kitchen sink, that typically holds less than 100 gallons. A grease interceptor is a large tank, usually buried outside, that typically holds 250 to 5,000 gallons and serves the whole kitchen.
Both devices do the same job. They slow kitchen wastewater down so fats, oils and grease float and food solids sink before the water reaches the sewer. The City of Dallas requires one or the other in every commercial or institutional food service operation, and the 2021 Dallas Plumbing Code sets the size.
James Armstrong Plumbing, a Mesquite company led by Texas Master Plumber James Armstrong, clears, jets and camera-inspects the grease lines, kitchen drains and floor drains that feed these units. Our page on restaurant plumbing in Dallas covers that work.
Key takeaways
- A grease trap is a small indoor unit, usually under 100 gallons, often below a sink.
- A grease interceptor is a precast concrete tank of about 250 to 5,000 gallons, usually outdoors.
- Both catch fats, oils and grease that float and food solids that settle.
- Dallas and Mesquite both require one in food service operations.
- Many kitchen backups start in the pipe between the sinks and the trap, which the unit does not protect.
What is the difference between a grease trap and a grease interceptor?
A grease trap and a grease interceptor do the same job at different sizes. The Dallas Water Utilities Pretreatment Program, which oversees what businesses send to the city sewer, describes them this way:
- Grease trap: the smaller indoor device, usually less than 100 gallons, usually steel, often a single compartment, and until recently typically installed below a sink.
- Grease interceptor: the large precast concrete tank, typically 250 to 5,000 gallons, with two separate compartments.
People say “grease trap” for both. In any grease trap vs grease interceptor question, size, location and piping change; the job does not.
What is a grease interceptor?
A grease interceptor is a large tank, usually buried outside, that holds kitchen wastewater long enough for grease to float to the top and solids to settle, so the clearer water in the middle can flow on to the sewer. Water slows and cools in the first compartment, then the clearer middle layer moves on to the second.
The U.S. Environmental Protection Agency (EPA) runs the National Pretreatment Program, which bars “solid or viscous pollutants in amounts which will cause obstruction” under 40 CFR 403.5(b)(3). Its fact sheet on controlling fats, oils and grease from food service establishments (EPA-833-F-12-003, September 2012) says these devices must be “designed and sized appropriately to allow FOG to cool and separate in a non-turbulent environment.” FOG is the EPA’s short name for fats, oils and grease.
A tank that is too small, or water that enters too fast, lets grease ride through to the sewer.
Where does a grease trap or interceptor sit in a commercial kitchen?
A grease trap sits inside, close to the fixtures it serves; a grease interceptor sits outside, in the ground, and serves many fixtures at once.
A trap often sits under a three-compartment sink or in the floor near the dish area, on a short pipe. An interceptor sits under round access lids outside. The kitchen lines run out under the slab to reach it, and that long run is where many kitchen backups start.
How does flow rate decide which one a kitchen needs?
The more water a kitchen sends at once, the more volume and time the unit needs to separate grease.
A small trap is usually rated by flow, in gallons per minute. A large interceptor is usually rated by holding capacity in gallons, because it relies on volume and time to slow and cool the water. A coffee shop with one prep sink sends small bursts; a full-service restaurant with a three-compartment sink, a pre-rinse station and floor sinks sends a large, steady volume.
Who decides what size grease interceptor a kitchen needs?
The plumbing code decides it. In Dallas, the city checks the math before the kitchen is built.
Dallas. The City of Dallas Planning and Development Department requires a Grease Interceptor Submittal for every food service establishment that needs a Health Permit. The submittal must:
- Go in with the construction documents for plan review. The field plumbing inspector also asks for it during construction.
- Include sizing calculations under Chapter 10, Traps, Interceptors and Separators, of the 2021 Dallas Plumbing Code, which is the 2021 International Plumbing Code (IPC) with Dallas amendments.
- Include the manufacturer’s cut sheet, showing the unit meets one of the listings Chapter 10 approves.
Mesquite. The City of Mesquite requires a grease interceptor on the wastewater discharge of any facility that prepares or serves food. The city notes that a grease interceptor is commonly called a grease trap.
Other DFW cities set their own rules, so check with your city before you build out or change a kitchen.
What does a grease trap or interceptor catch?
Both catch the same two things: grease that floats and food solids that sink.
- Fats, oils and grease are lighter than water and collect at the top.
- Food solids such as rice, batter and coffee grounds settle to the bottom.
Neither catches everything. Hot water and detergent can carry some grease through, and rinsed food waste fills a unit faster.
What are the signs a grease trap or interceptor is overloaded?
The signs show up first at the lowest kitchen fixtures:
- Slow drains at several kitchen fixtures at once, especially floor drains and floor sinks.
- Water rising in a floor sink when the dish machine or the three-compartment sink drains.
- A strong grease or sewer smell near the unit’s lid or the kitchen floor drains.
- Grease showing downstream in the sewer cleanout past the unit.
If the unit is full, it needs service. If the unit has room and the kitchen still backs up, the blockage is in the pipe, and that is plumbing work. If restrooms back up too, suspect the main line; see sewer line repair in Dallas.
Why does the kitchen drain line clog before the grease trap?
When a kitchen drain backs up and the grease trap is not full, the blockage is in the pipe upstream of the trap. Grease cools and sticks to the drain line between the sinks and the trap, and the trap does nothing to protect that stretch of pipe.
Grease leaves the sink warm, then cools, turns sticky and coats the pipe wall. Each service adds a layer. Over weeks the pipe narrows until water backs up at the lowest fixture, even with a well-kept interceptor outside. Four things make it worse:
- A long run to an outdoor interceptor gives grease more distance to cool and stick.
- Hot water and detergent carry grease deeper into the line before it sets.
- Low spots and rough pipe, such as a sag under the slab or scaled older cast iron, hold grease.
- Food solids give grease something to bind to.
The same EPA fact sheet cites the agency’s August 2004 Report to Congress (EPA-833-R-04-001): grease from restaurants, homes and industrial sources is the most common cause of reported sewer blockages, at 47 percent. Grease “solidifies, reduces conveyance capacity, and blocks flow.”
The fix is a cleaned pipe, not a bigger trap. Our drain cleaning service in Dallas covers that work.
How do you keep a kitchen grease line clear?
Keep grease out of the drain, and clean the line properly when it builds up.
- Scrape plates and pans into the trash before they reach the sink or the dish machine.
- Keep strainers in every sink and floor sink, and empty them into the trash.
- Put used fryer oil in its collection container, never down a drain.
- Skip chemical drain openers on a grease line. They rarely clear grease, and the caustic water is a hazard for whoever opens the line.
A cable punches through grease and gets water moving. Hydro jetting scours grease off the pipe wall, which suits grease lines that clog again after cabling. A camera inspection first shows whether the pipe is sound enough to jet; see our commercial hydro jetting page.
Between cleanings, a degreasing treatment helps break grease down before it hardens. Some cities restrict additives in grease traps, so check with your city before treating a line that feeds one. Plano’s Code of Ordinances, Sec. 21-362, for example, bars enzymes, bacteria and other additives in a grease trap unless the city approves them.
Frequently asked questions
Is a grease trap the same thing as a grease interceptor?
A grease trap and a grease interceptor do the same job at different sizes. Dallas describes a trap as a small indoor unit, usually under 100 gallons, and an interceptor as a concrete tank, typically 250 to 5,000 gallons.
What is a grease interceptor?
A grease interceptor is a large tank, usually buried outside, that holds kitchen wastewater long enough for grease to float to the top and solids to settle, so the clearer water in the middle can flow on to the sewer.
Does a restaurant in Dallas need a grease trap or interceptor?
Yes. The City of Dallas requires one or the other in every commercial or institutional food service operation, and the 2021 Dallas Plumbing Code sets the size.
How do you know which size a kitchen needs?
The plumbing code decides it. In Dallas, sizing calculations under Chapter 10 of the 2021 Dallas Plumbing Code go in with the construction documents for plan review.
Why does my kitchen drain back up when the grease trap is not full?
The blockage is in the pipe upstream of the trap. Grease cools and sticks to the drain line between the sinks and the trap, and the trap does nothing to protect that stretch of pipe.
Can hydro jetting clear a kitchen grease line?
Yes. Hydro jetting scours grease off the pipe wall, which suits grease lines that clog again after cabling. A camera inspection first shows whether the pipe is sound enough to jet.
Grease backing up in the kitchen?
Call James Armstrong Plumbing at 214-918-6109. A licensed plumber will find the blockage, clear it and explain what we found. Our commercial plumbing services in Mesquite cover everything else we handle for businesses.
About James Armstrong Plumbing
James Armstrong Plumbing was founded in 1995 and has more than 30 years of experience. James Armstrong is a Texas Master Plumber, License M-39428. We are licensed and insured, and BBB A+ rated since 2018. Our shop is at 844 Dalworth Dr, Suite 10, Mesquite, TX 75149. Call 214-918-6109.
This article is general information, not professional or legal advice. Confirm current requirements with your city before you build or change a kitchen.
Both units do the same job: they slow kitchen wastewater down so grease floats and food solids sink before the water reaches the sewer. The differences are size, location and the pipe that feeds them.
| Grease trap | Grease interceptor | |
|---|---|---|
| Where it sits | Inside, close to the fixtures it serves, often under a three-compartment sink or set into the floor near the dish area | Outside, usually in the ground under round access lids |
| Size (City of Dallas description) | Usually less than 100 gallons of liquid holding capacity | Typically 250 to 5,000 gallons of liquid holding capacity |
| Construction | Usually steel, often a single compartment | Precast concrete tank with two separate compartments |
| How it is usually rated | By flow rate, in gallons per minute | By holding capacity, in gallons |
| What it serves | The nearby fixtures it serves, through a short pipe | Many fixtures at once, through kitchen lines that run out under the slab |
| What it catches | Fats, oils and grease that float; food solids that settle | Fats, oils and grease that float; food solids that settle |
| What it does not protect | The pipe upstream, between the sinks and the trap | The pipe upstream, which can be a long run where grease cools and sticks |
| Dallas rule | One or the other is required in every commercial or institutional food service operation, sized under Chapter 10 of the Dallas Plumbing Code | |
If the unit has room and the kitchen still backs up, the blockage is in the pipe. We clear and jet grease lines, kitchen drains and floor drains, and inspect them by camera. Call 214-918-6109.
This is general information, not legal advice. Confirm current requirements with your city before you build or change a kitchen.
