Slab Leak Repair in Frisco

Yes, as scheduled work. Our shop is at 844 Dalworth Dr in Mesquite, about 50 minutes from Frisco, so we book Frisco slab leak jobs with a set arrival window rather than emergency dispatch. If water is actively running right now, shut off your main and call a plumber based closer to you rather than waiting on our truck.

Very likely. Post-tension foundations became standard for new North Texas construction from the 1980s onward, and Frisco's growth happened almost entirely inside that era. You can usually confirm it yourself: look for a stamp in the concrete near the garage door, a placard on the garage wall, or small circular patches spaced roughly two to four feet apart on the outside of your foundation. Those patches are the anchor points where the cables were tensioned.

Not without locating the tendons first, and often the better answer is not cutting at all. Each tendon carries roughly 33,000 pounds of tension, and severing one can crack the slab, compromise the foundation, and injure whoever is standing there. On post-tension slabs we confirm foundation type before discussing method, scan for cable locations if cutting is being considered, and frequently recommend an overhead reroute instead.

The failed section of under-slab pipe is abandoned in place and new PEX is run through wall cavities and the attic, bypassing the slab entirely. No concrete gets cut, which makes it a common answer on post-tension slabs and on homes with stone, tile, or wide-plank flooring that would never match if it had to be replaced.

Timing. Frisco's earliest large developments date to roughly 2000 through 2005, which puts them at twenty to twenty-five years old. That is about when copper embedded in a slab has been through enough Blackland Prairie clay expansion and contraction cycles to show real fatigue. Frisco's first generation of slab leaks is arriving now rather than being an old-plumbing problem.

Permit requirements depend on scope, and Frisco applies a 6 percent technology fee to all permits as of August 1, 2026 under Ordinance 2026-05-40. What is certain is that every contractor working in Frisco must be registered with Building Inspections before a permit is issued, and a licensed journeyman must be on site at all times while plumbing work is in progress. Confirm your project's requirements with Frisco Building Inspections at 972-292-5301.

Frisco's eTRAKiT system lets anyone search currently registered contractors authorized to work in the city. Registration requires a valid trade license verified through the Texas State Board of Plumbing Examiners, proof of liability insurance, and a registration fee, and registered contractors are issued an R-Number. It is worth checking before anyone opens concrete in your house.

Detection runs $300 to $500, covering electronic and acoustic location and pressure testing so the leak is marked precisely before anything is opened. Repair cost comes as a flat written quote after detection, once we know your foundation type and whether an overhead reroute, tunneling, or a spot repair is the right method for your house.